Remington iLight IPL 3500 Guía De Uso Y Cuidado página 48

9.2 Treatments with your device
Follow these steps each time you treat an area:
1.
2.
3.
4.
5.
6.
7.
!
!
IPL3500_18817_V2.indd 48
Before treating an area, the skin should be shaved, clean, dry and
free of any powders, antiperspirants or deodorants. Do not wax,
pluck or tweeze the hair out.
NOTE: Do not use on moles, warts or other marks on the skin that
should not be treated.
Press the control button. The device will turn on, the level 1 energy
indicator light will be on, and a fan sound will start.
Approximately 1 second after pressing the control button, the
ready light will turn on (#4 in the diagram). The device is then
ready to use at the lowest energy level.
Set the energy level. Press the control button repeatedly to
increase the energy level until you have the level you want. The
energy level indicator lights indicate the energy level setting (refer
to section "8.2 Energy levels").
Decide if you wish to treat the area by Gliding or Pulsing (refer to
section "8.3 Pulsing and gliding").
Apply the treatment window to the skin (#5 in the diagram).
Make sure that the skin is spread evenly and smoothly. When the
treatment window is in full contact with the skin, the ready light
will start blinking slowly.
The device will first determine the color of your skin automatically
and it will flash a pulse of light onto your skin. You will feel a
mild sensation of warmth and tingling, and you may hear a
popping sound.
The device will not operate if your skin tone is too dark for
safe use.
If you are pulsing, remove the device from your skin. The
device will immediately recharge for the next pulse. After a
few seconds (depending on the energy level) the ready light
will turn on again, and will pulse when pressed against
the skin.
48
10/30/17 3:36 PM