Korg TRITON taktile Manual Del Usuario página 3

Introduction
Thank you for purchasing the Korg TRITON taktile USB
Controller Keyboard/Synthesizer.
In order to take full advantage of your new instrument,
please read this instruction manual carefully and use the
product as directed. You should also keep the instruction
manual for future reference.
1. Connections
Pedal switch
(PS-1 pedal switch, DS-1H
damper pedal, etc.)
Expression pedal
(EXP-2 foot controller, XVP-10
expression pedal, etc.)
TIP When you connect the unit to your Windows computer for
the first time, the driver included in the OS will be installed
automatically.
When the unit is turned on, the polarity of a pedal switch (sepa-
rately sold) is detected automatically. If you're using the pedal
switch, it should be connected before the power is turned on. At
power-on, you should not touch the pedal switch.
The standard USB-MIDI driver included in the Windows OS will
not allow The TRITON taktile to be used by two or more appli-
cations simultaneously. To allow The TRITON taktile25/49 to be
used by two or more applications simultaneously, you need to
install the KORG USB-MIDI driver. Please download the KORG
USB-MIDI driver from the Korg website, and install it following
the instructions in the supplied document.
If you connect The TRITON taktile via a USB hub, it may not
turn due to insufficient power. In that case, you should directly
connect The TRITON taktile to the USB connector on the com-
puter.
Use only the included USB cable.
TIP For additional details about that functions and parameters
of this unit, please refer to The TRITON taktile Parameter
Guide. You can download The TRITON taktile Parameter
Guide from the Korg website.
Standalone
MIDI IN
MIDI equipment
Connect the AC Adapter
This unit uses a commercial AC adapter conforming to
USB standards (DC5V 550 mA or higher), making it pos-
sible to use it as a standalone unit, without using a com-
puter.
When using the controllers on this unit, a MIDI message is
output from the MIDI OUT jack.
Be sure to use an AC adapter that conforms to USB2.0 stan-
dards. However, there may be cases where, depending on the
USB AC adapter used, it will not function normally even when
compatible with the standards.
When using an AC adapter, The TRITON taktile cannot be used
for controlling the DAW software.
Connecting with headphones and audio equipment
Headphones, powered monitors or mixers should be con-
nected to the OUTPUT jack on the right side of the main
unit.
TIP When using a cable equipped with an adapter for conver-
sion between standard and mini, hold the adapter when
inserting or removing the plug.
When connecting a cable, do so with the device power OFF.
Connecting with the power ON could cause damage to the con-
nected equipment or cause it to malfunction. Also, be sure to
turn down the volume on all devices that you want to connect.
You should avoid wearing headphones for extended periods of
time at loud volume.
Commercial USB AC adapter
(USB 2.0 compatible)
Computer
Headphones
3