Troubleshooting; Disposal And Recycling - Blaupunkt MS6000 Manual De Instrucciones

TROUBLESHOOTING

PROBLEM
The motor will not run
The motor hums
but cannot run or
runs slowly
Flow blows and circuit
breaker trips
repeatedly

DISPOSAL AND RECYCLING

This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
WARRANTY
This product has 2 Years Warranty for manufacturing defects. The warranty period will be counted from the date of purchase
of the product, according to purchase invoice. Product warranty only covers manufacturing defects, defects resulting from
improper use, such as dropping, improper transportation, connection to the mains power supply not in compliance with the
voltage specified in this manual, insertion of foreign objects and natural wear of parts and parts Such as plastic parts (caps,
buttons, handles, latch locks, power cables, etc.) and metal parts (wires, motors, etc.).
Also not covered are damages due to agents of nature, lightning, food, sea, oxidation, humidity etc.). The product will lose its
warranty if it presents defects, which after analysis by our technicians, are characterised as being improperly used, used for
professional use or for the purpose for which it is not intended (according to the Owner's Manual). This warranty will be void if it
is found that the device has been tampered with, has been repaired by a person or service not authorised by Blaupunkt.
The guarantee is only valid with the receipt/invoice provided at purchase.
We undertake to provide the above-mentioned services within the warranty period only in places where it maintains an
authorised service. Consumers not located near an authorised service centre are responsible for the costs and risks of transport
to an authorised service.
Territorial Limitations: Any repair, replacement, or support of the Products provided under the Warranty (or any other support
service offered in our sole discretion), shall be restricted to, and provided solely within, the Distribution Territory as then in effect
on the date the Product is delivered to you. If you purchase a Product within a defined Distribution Territory and later transport
the Product outside of the Distribution Territory, we cannot provide returns, warranty, out-of-warranty, or aftermarket support of
any kind outside the Distribution Territory.
Natural 'wear and tear' is not covered under warranty.
This product is for domestic use only.
CAUSE
1. Switch in OFF position
2. No electrical power at the
wall outlet electrical panel.
3. The switch has broken down
4. The motor has broken down
5. Defective cable
1. Low voltage
2. Loose electrical connections
3. Wrong gauge wire or wrong
length of extension cords
4. Shorted or open motor
winding
1. Circuit is overloaded
2. Wrong gauge wire or length
of extension cord
3. Motor shorted or seized
SUGGESTED ACTION
1. Make sure saw is plugged in and switch is pressed
2. Check circuit breaker or fuse at the electrical panel.
3. Replace the switch
4. Contact a service center for replacing motor
assembly.
5. Replace cable
1. The circuit is overloaded
2. Check all electrical connections.
3. Check extension cord chart for
proper extension cord usage.
4. Contact service center for
replacing motor assembly.
1. Disconnect other electrical
appliances from the circuit or
operate saw on its own branch
circuit.
2. Check extension cord chart for
proper extension cord usage.
3. contact service center for
Replacing motor assembly.