Blaupunkt MS6000 Manual De Instrucciones página 9

FIG.M3
Blade
Inner
flange
Outer flange
FIG.M5
flanges. To refit the blade, follow the above procedure in reverse order.
CAUTION: ALWAYS install the blade with the blade teeth and the
arrow printed on the side of the blade pointing down at the front of
the saw. The direction of blade rotation is also stamped with an arrow
on the upper blade guard.
REPLACING THE CARBON BRUSHES (SEE FIG. N1-N3)
Check the carbon brushes regularly. If the carbon brushes are worn
down to about 4mm replace them with the new set (not supplied). It
must be replaced in pairs.
With a suitable slotted screwdriver turn the cap anti -clockwise until
the carbon brush is released, replace the brush and make sure that
they fit well and are secured within the brush retainer.
4. MOVING THE SAW
When transporting the saw with fixed locations, make sure that the
saw head is locked in the lower position.
2) The rotary table locking knob, the bevel lock lever and the slide
rod securing knob, must all be securely tightened.
3) Use the transportation handle to lift the saw. Do not lift the saw
by the switch handle.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
FIG.M4
Bolt-
left
hand
thread
FIG.N1
FIG.N2
6 mm (1/4')
FIG.N3