Blaupunkt MS6000 Manual De Instrucciones página 8

b
FIG.K1
FIG.K2
MAINTENANCE
WARNING: Remove the plug from the socket bafore carrying out
any adjustment, servicing or maintenance .
When ali the adjustments, settings ar maintenance have been
dane, make sure that ali keys and wrenches have been remaved
and that ali screws, balts and ather fittings are securely tightened.
There are no user serviceable parts in your power toai. Nevar use
water or chemical cleaners to clean your power toai.
Wipe clean with a dry cloth. Always store your power toai in a dry
place. Keep the motor ventilation slots clean. Keep all working
contrais free of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your power toai.
lf the supply cord of this power toai is damaged, it must be replaced
by a specialiy prepared cord available through the service.
1. PRECISION SETTING OF ANGLES (SEE FIG. K1, K2, L1, L2)
While the machine has been factory set, it is advisable that the Oº
setting of the rotary table and the 90º perpendicular setting of the
tilt be checked, as these positions may have moved in transit. (Ensure
power is disconnected while making these adjustments).
To confirm the 0º rotary table setting, set the rotary table at 0º and
tighten the rotary table locking knob. Check that the angle between
the straight guide and the blade is 90º using a try square (b, not
supplied) as shown in Fig. K1. If the angle requires adjustment, loosen
the locking screws for a straight guide, and align the fence against the
try square.
Re-tighten the locking screws for a straight guide. (SEE FIG. K 1, K2)
Similarly, check that the angle of the blade to the face of the rotary
table is 90º. If necessary, adjust the tilt angle of the saw head at
the 90º position: loosen the bevel lock (20) and adjust the Oº bevel
adjustment screw (e) to bring the saw blade into alignment with the
square. Loosen the head screw (e) holding the pointer of the bevel
scale (21) and adjust the position of the pointer so that it accurately
indicates zero on the scale. Retighten the screw. Retighten the bevel
lock (20) and the Oº bevel adjustment screw. (SEE FIG. L1. L2).
2. CHANGING THE SAW BLADE (SEE FIG. M1-M5)
Disconnect the saw from the power supply. Remove the linkage screw
with a screwdriver.
Press the blade spindle lock (22) and rotate the blade until it is locked,
then rotate clockwise to loosen and remove the blade securing bolt,
the outer flange with the hex key.
NOTE: Blade securing bolt has a left-hand thread.
Remove the blade, (we recommend the use of a stout glove for this).
Clean any sawdust and debris from the arbor and saw blade securing
b
FIG.L1
21
FIG.L2
FIG.M1
FIG.M2