Blaupunkt MS6000 Manual De Instrucciones página 7

1) Connect the machine to a power outlet, ensure that the mains
cable is clear of the blade and base plate.
2) Position the material to be cut on the rotary table, ensure it is firmly
clamped so that it will not move during cutting.
3) Ensure that the rotary table locking knob (7) and bevel lock lever
(20) is tightened before cutting.
4) Press the trigger switch and allow the saw blade to run up the
speed.
5) Still holding the trigger, using your thumb simply press the safety
release lever. It will then be possible to push the saw head down by
the handle.
6) Continue to move the saw head down smoothly and make
the cut exerting only gentle pressure on the downward stroke, letting
the saw do the work.
4.MITER CUT (SEE FIG. I1, I2)
A mitre cut is made at Oº bevel and any mitre angle in the range
from 45 º left to 45 ºright. It can be made as a chop cut. For most
convenient operation, your sliding mitre saw is equipped with mitre
detents for fast and accurate mitre cuts of common mitre angles
(Left:45 º,30 º,22.5 º,15 º;0 º; Right: Oº,15 º,22.5 º,30 º,45 º).
The rotary table locking knob (B)is used to lock the table at the
desired mitre angle. To adjust the mitre angle, put the saw on a
stable surface and fix it, loosen the rotary table locking knob (B)
counter-clockwise, hold the handle (1) firmly to rotate the saw head
to the desired position, then tighten the rotary table locking knob (7)
clockwise.
5. MITRE CUT (SEE FIG. J1, J2)
A bevel cut is made at Oº mitre and any bevel angle in the range of Oº
to 45º left.
The saw can be moved from the normal Oº perpendicular position to
an angled position down to 45 º from the horizontal, on the left only.
Loosen the bevel lock lever (20) and tilt the saw head to the left, until
the desired angle is reached on the bevel scale. Re tighten the bevel
lock lever and make your cut.
FIG.H1
FIG.H2
(20)
FIG.I1
FIG.I2
FIG.J1
FIG.J2
(7)
(20)