Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS REQUIRED FOR INSTALLATION
The following tools are required in order to install the
convector fan:
· Pipe wrench for the wet connections
· Flat tip and cross-headed screwdrivers
· Drill
· Scissors
ACCESSORY PARTS NORMALLY AVAILABLE ON THE MARKET AND REQUIRED FOR INSTALLATION
The following items are also required for installation purposes:
· Water pipe unions
· Condensation-proof tape
· Adhesive tape
CHOICE OF THE INSTALLATION SITE
Positions to avoid:
· Places in direct sunlight .
· Positions near heat sources .
· Damp places and positions where the unit could come into contact with water (e .g .: washrooms) .
· Places where shelves or furn iture could prevent the air from circulating correctly .
What to do:
· Choose a position without obstructions that could
hamper the air inlets and outlets .
· Choose a position where the appliance is easy to
install .
· Choose a position that complies with the recommen-
ded minimum space for maintenance work.
· Choose a position that allows air to freely circulate
around the room .
· Install the appliance so that the condensation can be
easily drained off .
· Choose a position possibly in the middle of the
room . Adjustment of the outlet air can then be optimi-
zed to reach all parts of the room .
· The best position of the fans is generally the one
that allows air to be blown on to the ceiling by means
of the Coanda effect. The fins can also be set in the
fully closed position, with the limitations shown in the
figure.
· Check to make sure that the chosen position allows
the panels to be sufficiently removed from the ceiling
to allow the installation and maintenance operations
to be carried out .
· Do not install the appliance where water can drip
on to it .
INSTALLATION
· Wire stripper
· Pipe cutters
· Pipe benders
· Measuring tape
· Level
· Goggles and protective gloves
Fig . 1
>1000
11
Publicidad
Capítulos
Tabla de contenido
