Removing Modules; Adjusting Surface Burner Low Flame Size - Amana AKGD3060 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Smoke Control Grill™
Install on right side only.
1. Turn controls to OFF position.
2. Remove grill from module.
3. Place grease pan in well.
4. Place end of module into cooktop well with air
shutters facing rear of well. Lower front of module
into well.
Front
5. Place grill grate on module.
Installing Griddle
1. Turn controls to OFF position.
2. Install module according to "Installing Smoke
Control Grill™ Module" section.
3. With grease trap toward rear of cooktop, place
griddle pan over burner.
• To remove griddle module turn all controls to OFF
and reverse steps above.

Removing Modules

1. Turn all controls to OFF . Make sure module is cool.
2. Using tab on front of module, lift up slightly.
• Do not lift module too high. Lifting module too
high can cause damage to orifices.
3. Pull module toward the front of cooktop and
carefully lift it out.
Rear
Well

Adjusting Surface Burner Low Flame Size

1. Push and turn burner control knob to LITE position.
• Burner sparks until turned from LITE .
2. Set burner control knob to low setting.
3. Remove burner control knob.
4. While holding valve stem stationary, turn screw in
center of burner control stem until flame is
adjusted.
• Use small blade screwdriver.
Control
knob
5. Replace burner control knob.
6. Turn surface burner control on and off to test burner
flame.
7. If flame is adjusted too low, flame may be easily
extinguished. Flame may be extinguished by drafts,
door opening or closing, heating and cooling vents,
ceiling fans, etc.
13
Adjustment
screw

Publicidad

Tabla de contenido
loading

Tabla de contenido