Gas And Electrical Installation Requirements; Junction Box Location - Amana AKGD3060 Serie Manual Del Usuario

Gas and Electrical Installation
Requirements
If an external electrical source is used when appliance
is installed, it must be electrically grounded in
accordance with local codes or, in absence of local
codes, with current National Electrical Code ANSI NFPA
70, or CSA Standard C22.1, Canadian Electrical Code,
Part 1.
When installed in mobile housing, installation is to be in
accordance with CSA standard Z241.1 gas equipped
mobile housing. All electrical connections are to be
made in accordance with CSA standards Z240.6.1
electrical requirements for mobile homes.
The installation of appliances designed for
manufactured (mobile) home installation must conform
with Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280, or when such
standard is not applicable, the Standard for
Manufactured Home Installation, ANSI225.1/NFPA
501A-Latest Edition, or with local codes or the standard
CAN/CSA-z240MH, "Mobile Homes", and with local
codes where applicable.
Installation of this product must conform with local
codes or in absence of local codes, with current
Canadian Gas Installation Code CAN/CGA-B149.2.
Use a dedicated 120 volt, 60 hertz, 3-prong receptacle
protected by a 15-amp circuit breaker or time delay
fuse. A qualified electrician should confirm the outlet is
properly grounded. Cooktop includes 4-foot power cord
attached to bottom of cooktop at back, left corner.
If a 2-prong outlet is encountered, cooktop owner must
replace outlet before using cooktop. Do not cut off cord
or remove grounding prong.

Junction Box Location

Power supply enters cooktop in right, rear corner.
Junction box must be located within 30 inches of power
supply entry point. Locate junction box within shaded
area.
A—12 inches
B—4½ inches (From top of countertop)
C—24 inches
C—Center line
L
9
A
B
C L