Error Messages - KBL megaSun 5600 Manual De Instrucciones

Error messages

Faults „Bus Error", „Bus Relais Error", „Hardware Error" and "Aqua low" do not occur with the KBL/5 processor due
to its equipment and processor structure.
Status Status
message message
KBL/4 KBL/5
Abluft Abluft
(Exhaust air) (Exhaust air)
Maximum max. time
tanning time!
Aqua low
Aqua 0%
Hardware
error
Bus Relais
Error
E05:BUS:REL
E04:BUS:VOICE
E02:BUS:TMP
52
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
Status description
Bi-metal switch triggers.
Incoming enabling signal from coin-box
system longer than approved, i.e. the
value specifi ed under "Maximum tanning
time" (voltage remains connected).
The content of the aquaCool canister
is suffi cient for another 750 spraying
-
seconds (2.5 operating hours at a cycle
time = 1 minute).
750 spraying seconds (2.5 operating
- hours at a cycle time = 1 minute) have
expired.
- Main board defective.
- AquaCool Relay board defective.
- I²C bus faulty.
Communication between control and
-
Voice-MP3 Player has been interrupted.
I2C Temperature sensor is faulty or
-
disturbed.
Remedy
Check the air-intake/air-discharge system and the fan.
Let the tanning system cool down and acknowledge
the message by pressing the START button. If the fault
persists, contact your Customer Service.
Disconnect the device from the coin-box system.
Replace the empty aquaCool canister with a full one. Do
not replace aquaCool with any other liquid. If the canister
is not empty, replace the liquid-level sensor (contact your
Customer Service).
Replace the empty aquaCool canister with a full one. Do
not replace aquaCool with any other liquid. If the canister
is not empty, replace the liquid-level sensor (contact your
Customer Service).
Replace the main board (contact your Customer
Service).
Replace the AquaCool Relay board (contact your
Customer Service).
Contact your Customer Service.
1. Check the „Voice" SD Card.
2. Contact your Customer Service.
Contact your Customer Service.