Entering Pin Iii - KBL megaSun 5600 Manual De Instrucciones

PIN II
1. Invoke the
2. Press 5 (plus button) or 0 (minus button) to select
easyCare
.
3. Open the submenu by pressing START and then
EC.TIME
select
button).
4. Enter a duration of time between 8 and 20 minutes.
5. Press START to save the settings and STOP to
exit the menu.
DISPLAY ERYTHEMA-EFFECTIVE IRRADIANCE
This value is given for information only.
PIN II
1. Invoke the
2. Press 5 (plus button) or 0 (minus button) to select
easyCare
.
3. Press START to open the submenu and select
rLi EerDe
(bed) or
or 0 (minus button).
4. Exit the menu by pressing STOP.
TANNING CONTROL ONLY VIA EASYCARE
You can determine whether easyCare can be
deactivated or not.
PIN II
1. Invoke the
easyCare
2. Select
0 (minus button).
3. Press the START button to open the submenu and
EConly
select
button).
4. Select the desired setting by pressing 4 (plus
button) or 9 (minus button). ON=easyCare
cannot be deactivated, OFF=easyCare can be
deactivated.
5. Press START to save the settings and leave the
menu by pressing STOP.
SESSION TIME AT EASYCARE UNIT POSSIBLE
Here you can determine whether it will be possible to
set the session time via the easyCare display.
PIN II
1. Invoke the
easyCare
2. Select
36
M a n u a l d e i n s t r u c c i o n e s | megaSun 5600
menu.
using 5 (plus button) or 0 (minus
menu.
(canopy) using 5 (plus button)
menu.
by pressing 5 (plus button) or
using 5 (plus button) or 0 (minus
menu.
by pressing 5 (plus button) or
0 (minus button).
3. Press START to open the submenu and select
T.Display
button).
4. Select the desired setting by pressing 4 (plus
button) or 9 (minus button). ON=setting via display
possible, OFF=setting via display impossible.
5. Save the settings by pressing START and exit the
menu via STOP.
SENSOR TEST
The sensor test is carried out to check whether the
sensor is functional.
1. Invoke the
easyCare
2. Select
Ee-
0 (minus button).
3. Press START to go to the submenu and select
TEST
by pressing 5 (plus button) or 0 (minus
button).
4. Press the sensor onto the skin in order to start
the test.
5. Press STOP to leave the menu.
RELAY TEST
The relay test is used to test the functionality of any
possible combination of power levels of tubes and
sunlamps. In order to be able to carry out this test,
there must be an incoming timer signal.
1. Invoke the
easyCare
2. Select
0 (minus button).
3. Open the submenu by pressing START and select
EC-REL. TEST
button).
4. Press 1 (minus button) to start the test.
5. Press the STOP button to exit the menu.

Entering PIN III

If you enter your PIN Ill here, you will access the next
service level. Level III is exclusively reserved for trained
service staff!
by pressing 5 (plus button) or 0 (minus
PIN II
menu.
by pressing 5 (plus button) or
PIN II
menu.
by pressing 5 (plus button) or
using 5 (plus button) or 0 (minus
④