Maintenance; Replacing The Mains Fuse; Cleaning Recommendations - Promax GV-698+ Manual De Instrucciones

Colour pattern generator GV-698+

6 MAINTENANCE

6.1 Replacing the mains fuse

The fuseholder lid is placed in the mains base (see figure 1).
To substitute the fuse, disconnect the power cord.
With an appropriate screw driver remove the fuseholder lid.
Substitute the melt fuse for another of the following characteristics:
FUSE TYPE SHOULD BE: 5 x 20 mm., and:
0.5 A
1 A
AVOIDING THIS DIRECTIONS COULD DAMAGE THE
EQUIPMENT.
When inserting the fuseholder lid be careful that the voltage selector is in the
correct position according to the mains.

6.2 Cleaning recommendations

TO CLEAN THE COVER, TAKE CARE THE INSTRUMENT IS
DISCONNECTED.
DO NOT USE SCENTED HYDROCARBONS OR CHLORIZED
SOLVENTS.
PLASTICS USED IN THE CONSTRUCTION OF THE COVER.
The cover should be cleaned by means of a light solution of detergent and
water applied with a soft cloth.
Dry thoroughly before using the system again.
07/2018
T 250 V FOR
T 250 V FOR
SUCH PRODUCTS
IMPORTANT
220, 230/240 V
110 and 125 V
MAY ATTACK TEH
CAUTION
CAUTION
Page 29