EGO LM2000 Manual De Operación página 25

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTICE: to re-install or replace the blade, be sure to replace the
parts in the exact order in which they were removed (Fig. 22).
 align the inner flange with the shaft and assemble it in
place.
 While wearing protective gloves, position the blade on the
inner flange with the recess (as shown in Fig. 23) toward
the mower.
 While still wearing protective gloves, move the blade by
hand to align the round hole in the blade with the round
pin on the inner flange, and the semi-round hole with the
semi-round pin (Fig. 24).
 turn the bolt clockwise into the shaft by hand to
pre-tighten.
 place a metal rod (e.g., a manual screwdriver) into the
fixing hole to act as a stabilizer, then use a 9/16 inch
(14mm) torque wrench (not included) to tighten the bolt
clockwise. the recommended torque for the blade bolt is
36-43 ft-lb (49-59nm) (Fig. 21).
23
24
Semi-round pin and Hole
56-VOlt litHium-iOn COrDleSS laWn mOWer — lm2000
recess
round pin and Hole
25

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Power+ lm2000

Tabla de contenido