EGO LM2000 Manual De Operación página 27

6. replace the blade on the mower
and tighten it securely (please see
inStalling tHe BlaDe)
WARNING: an unbalanced blade will
cause excessive vibration when rotating
at high speeds. it may cause damage to
mower and could break causing personal
injury.
LUBrIcaTION
 lubricate the axle on the inside
of the wheels and deck height
adjustment joint at least once a
season with light oil (or motor oil)
(Fig. 27a & 27b).
 lubricate the spring and pivot
pin in the quick-adjust lever, the
torsion spring and pivot of the rear
discharge door periodically with
light oil to prevent rust (Fig. 27c &
27d).
repLacING THe TraILING sHIeLd
WARNING: always remove the safety
key and battery pack when servicing or
transporting the mower.
WARNING: never operate the mower unless the trailing shield is in place and working. never operate the mower with
damaged safety devices. Failure to do so can result in personal injury.
the trailing shield is subject to wear and damage, which could expose moving
parts or allow objects to be thrown. For safety protection, frequently check the
trailing shield and replace it immediately with only the identical replacement
part, listed in this manual.
1. to remove the trailing shield, release the bail switch to stop the mower.
remove the battery pack and safety key.
2. turn the mower on its side.
3. remove the four screws with a phillips screwdriver; remove the press bar
(Fig. 28).
4. replace with a new trailing shield and reattach it with the press bar and
screws.
27a
axle on the inside of the
wheels
27c
Spring
pivot pin
56-VOlt litHium-iOn COrDleSS laWn mOWer — lm2000
27b
Deck Height adjustment
Joint (on rear wheels)
27d
pivot
torsion Spring
28
press
Bar
Screws
trailing
Shield
27