Electrical Connections - DITEC OBBI3BH Manual Para La Instalación Y El Mantenimiento

3.8 Fit the piston onto head bracket by means of the pin [G]
GB
provided (fi g.11). For correct operation, the geared motors
must be mounted with the motor housing at the top.
3.9 Release the geared motor (see RELEASING and LOCK-
ING Instructions) and move the gate by hand to check for
smooth movement throughout. Slightly lubricate front and
rear joints.
3.10 Fit the tube cover [12] with the plug [13] and gasket and
secure it to the geared motor by means of the screw [H]
and [M] provided (fi g. 12). Fit properly, making sure that
the slits on the closing plug [13] are turned downwards so
as to favour water drain-off.
3.11 Secure the casing [10] into place by means of screw [N]
paying attention to the position of the wire (fi g. 12).
4.

ELECTRICAL CONNECTIONS

The electrical connections and the startup of the Obbi 3BH are
illustrated in fi g. 13 and 14 and in the installation manuals of the
control panel D2H and Logic C22/C22S.
5. MAINTENANCE
months)
Power off (230 V~ mains and batteries, if installed):
- Lubricate front and rear joints.
- Lubricate the gate leaf hinges.
- Check the good conditions of the electric connection.
- Check that the fi xing screws of the geared motor are fi rmly
tightened.
Power on 230 V~ mains and batteries:
- Check the power adjustment.
- Check the good operation of all command and safety func-
tions (photocells).
- Check the good operation of the release system.
ATTENTION: For spare parts, see the spares price list.
OBBI - IP1639
PROGRAM (each 6
All right reserved
All data and specifi cations have been drawn up and checked
with the greatest care. The manufacturer cannot however take
any responsibility for eventual errors, ommisions or incomple-
te data due to technical or illustrative purposes
12