Hurricane PS 40 Manual De Instrucciones página 22

Anleitung PS 40 Hurricane
Fig. 18
B
C
A
• FUEL FILTER
CAUTION: Never operate your saw without
a fuel filter. The fuel filter should be replaced
after each 20 hours of use. Drain fuel tank
completely before changing filter.
1. Remove the fuel tank cap.
2. Bend a piece of soft wire.
3. Reach into fuel tank opening and hook fuel line.
Carefully pull the fuel line toward the opening until
you can reach it with your fingers.
NOTE: Do not pull hose completely out of tank.
4. Lift filter (A) out of tank (Fig. 19).
5. Pull filter off with a twisting motion. Discard filter.
6. Install new filter. Insert end of filter into tank
opening. Make sure filter sits in bottom corner of
tank. Use a long handle screwdriver to aid in filter
placement if necessary.
7. Fill tank with fresh fuel / oil mixture. See Section
FUEL AND LUBRICATION. Install fuel cap.
Fig. 19
A
• SPARK ARRESTER SCREEN (Fig. 20A)
NOTE: A clogged spark arrester screen will dramatically
reduce engine performance.
1. Remove the 2 bar retaining nuts (A) and loosen the
2 screws (B) that secure the chain brake cover
(Fig. 20A).
2. Remove the chain brake cover. Remove the 3
screws that hold the muffler to the cylinder. The muf-
fler will lift off after retaining screws are removed
(Figure 7-4B).
3. Separate muffler halves (C). Remove the metal
baffles (D) and spacer tubes (E).
4. Discard the used spark arrester screen and replace
it with a new one (F) (Fig. 20B).
5. Reassemble the muffler components and install the
muffler to the cylinder. Tighten screws securely.
Fig. 21A E
A
F
D
B
Fig. 20B E
22
20.02.2004 14:26 Uhr
• SPARK PLUG
NOTE: For efficient operation of saw engine, spark plug
must be kept clean and properly gapped.
1. Push STOP switch down.
2. Disconnect the wire connector (A) from the spark
plug (B) by pulling and twisting at the same time
(Fig. 21).
3. Remove spark plug with spark plug socket wrench.
DO NOT USE ANY OTHER TOOL.
4. Reinstall a new spark plug, gapped at .635mm.
Fig. 21
B
A
• CARBURETOR ADJUSTMENT
The carburetor was pre-set at the factory for optimum
performance. If further adjustments are necessary,
please take your unit to the nearest professional.
• STORING A CHAIN SAW
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instructions are
followed, fuel remaining in the carburetor will evaporate,
leaving gum-like deposits. This could lead to difficult
starting and result in costly repairs.
CAUTION: Never store a chain saw for longer
than 30 days without performing the following
procedures.
1. Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
2. Start the engine and let it run until the unit stops to
remove fuel from carburetor.
3. Allow the engine to cool (approx. 5 minutes).
4. Using a spark plug wrench, remove the spark plug.
5. Pour 1 teaspoon of clean 2-cycle oil into the
combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace
spark plug (Fig. 22).
NOTE: Store the unit in a dry place and away from
possible sources of ignition such as a furnace, gas hot
water heater, gas dryer, etc.
Fig. 22
Seite 22
GB