Midea MLH52S7AGS Manual De Usuario E Instrucciones De Instalación página 31

Problem Possible Cause
No power/ Washer is unplugged
washer not
working or
dead
Washer is unplugged
Circuit breaker/fuse is
tripped/blown
Automatic self system
checks
Snags, holes, Overloaded
tears, rips
or excessive
wear
Pens, pencils, nails,
screws or other objects
left in pockets
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers and sharp objects
left in pockets
Control time This is normal
wrong or
changes
Not enough This is normal
water
Washer Pump clogged
pauses or
has to be
restarted, or
washer door
is locked and
will not open
What To Do
• Make sure cord is
plugged securely into a
working outlet.
• Turn cold faucet fully on.
• Check house circuit
breaker/fuses. Replace
fuses or reset breaker.
Washer should have
separate outlet.
• First time the washer is
plugged in, automatic
checks occur. It may take
up to 20 seconds before
you can use your washer.
This is normal operation.
• The dry weight of the
load should be less than
22 lbs.
• Remove loose items from
pockets.
• Fasten snaps, hooks,
buttons and zippers.
• During spin the washer
may need to rebalance
the load sometimes
to reduce vibrations.
When this happens,
the estimated time is
increased causing time
left to increase or jump.
• Horizontal washers do
not require the tub to fill
with water like top-load
washers.
• See page 25 on how to
clean the Pump Filter.
31