Troubleshooting - Hoover FloorMate SpinScrub Manual Del Propietário

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug cleaner before servicing.
probleM
Cleaner won't
run
low suction
Water puddling
behind cleaner
Won't pick up
dirty solution
Cleaner solution
won't dispense
brushes won't
rotate

5. troubleshootinG

WARNING
!
possible Cause
1. Power cord not firmly plugged
into outlet.
2. Blown fuse or tripped breaker.
1.Washable Filter is dirty.
2. Dirty Water Tank full and the
automatic shut-off engaged.
3. Tanks not in place.
4. Filter or Filter lid not in place.
5. Nozzle not in place.
1. Wrong detergent used.
2. Clean Water Solution Tank not
in place.
3. Dirty water tank full.
1. Dirty Water Tank not in place.
2. Dirty water tank full.
3. Filter or Filter lid not in place.
1. Tanks not in place.
2. Clean Water Solution Tank is
empty.
1. Blown fuse or tripped breaker.
!
possible solution
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
1. Clean Washable Filter.
2. Empty the Dirty Water Tank.
3. Make sure tanks are locked in place.
4. Make sure Filter and Filter lid are properly
positioned.
5. Make sure Nozzle is replaced properly and
locked.
1. Use recommended detergents to reduce
foaming.
2. Make sure Clean Water Solution Tank is
installed properly.
3. Empty dirty water tank.
1. Make sure Dirty Water Tank is installed
properly.
2. Empty Dirty Water Tank.
4. Make sure Filter and Filter lid are properly
positioned.
1. Make sure tanks are locked in place.
2. Refill Clean Water Solution Tank.
1. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
(1) Push ON/OFF switch to turn cleaner OFF.
(2) Unplug the cleaner.
(3) Wait one minute.
(4) Plug the cleaner into electrical outlet.
(5) Push the ON/OFF switch again to turn
cleaner ON.
If the brushes continue to stall and the breaker
trips again, clean the brushes to remove debris.
13