The Tanks - Hoover FloorMate SpinScrub Manual Del Propietário

the tanks:

Clean water solution tank
(upper tank)
Turn cleaner off and disconnect from electrical
outlet.
The Clean Water Solution Tank holds detergent
and water that is to be dispersed onto the surface
being cleaned.
how to fill
Place carpet cleaner handle in the upright, locked
position.
2.8 To remove tank, squeeze release button and
pull tank straight out.
Carry tank to a sink.
2.9 Rotate tank cap counter-clockwise and lift up to
remove cap (A).
2.10 Turn cap (B) upside down to serve as a
measuring cup.
For hard surface floors such as vinyl, linoleum,
marble, laminate wood, polyurethane sealed wood
or other wood floors that can normally be cleaned
using water, use one cup (2 oz.) HOOVER
Floor Detergent.
Check for worn spots or joint separations before
using, as these conditions could lead to damaged
flooring when using water to clean floor.
2.11 Pour cleaning concentrate into tank (C). Fill
tank to fill line (D) (1 quart) with warm water.
2.12 If rubber ring (E) on cap has become dislodged,
reposition it with uneven side against ledge (F) as
shown.
2.13 Replace cap. Rotate cap clockwise until it
locks in place. Cap must be locked in place for
proper performance and to prevent leaking.
2.14 Slide tank straight into position until latch
snaps in place.
CAUTION
!
DO NOT use cleaning concentrates that
contain solvent based ingredients.
2.8
2.10
2.12
e
®
Hard
2.14
!
8
2.9
A
2.11
C
b
2.13
F
d