Spinscrub ® Mode Selector; The Tanks; Clean Water Solution Tank - Hoover MAX Extract DUAL V Manual Del Propietário

spinsCrub
®
Your SteamVac ® cleaner has two agitator brush
settings.
SPILL PICK-UP - brushes OFF for picking up spills
or cleaning carpets and hard floors when brushing
is not desired.
POWER SCRUB - brushes at maximum speed for
cleaning carpets
Slide setting selector to the desired setting before
cleaning.

the tanks:

Clean water solution tank

(upper tank)
2.7 The clean water tank (C) holds the water that
will either be mixed with detergent for cleaning the
carpet or floor, or used to rinse the carpet or floor.
The detergent container (D) is permanently attached
to the water tank. It holds the detergent that mixes
with the water.
how to fill
Unplug cleaner from electrical outlet.
To remove tank, press down on tank handle and pull
forward.
2.8 Fill tank (E) with hot tap water.
CAUTION
!
Do not fill with water above 140°F (60°C).
2.9 - 2.10 Fill detergent container (F) with Hoover
Carpet/Upholstery Detergent.
Replace container cap and tighten.
2.11 Position bottom of tank onto cleaner using one
hand on each side of the tank to center it on the unit.
IMPORTANT
The tank pivots towards the back of the unit.
Push the top of the tank and tank handle while
supporting the back of the unit with your other
hand.
IMPORTANT
Use only HOOVER
They are specially formulated for use with your
SteamVac ® cleaner. Non-Hoover
solutions may harm the machine and void the
warranty.
Actual model may vary from images shown.
Mode seleCtor
!
® SteamVac ® detergents.
® cleaning
2.6
2.7
C
2.9
F
®
2.11
8
2.8
D
2.10
E