Tank Status; Emptying The Dirty Water Recovery Tank - Hoover PLATINUM F8100900 Manual Del Propietário

3. HOW TO OPERATE
Ta n k Status I nd i ca t or s
The computerized controls will perform a self diag-
notics test the first time the machine is powered
up after being plugged in. This process takes 5
seconds during which all of the lights on the control
panel will flash. This is normal.
The appropriate tank status light will blink when
the Clean Water or Detergent Tank is empty.
In some circumstances, "soft water" or certain
Emp tyin g th e Di rty Wa te r Re c ov er y Ta n k
Turn carpet cleaner off and unplug from outlet. Do not use without float in place. If broken or dislodged, take
to an authorized Hoover
3.8
3.8
Lower cleaner han-
dle to the floor.
12
detergents might not be recognized by the sen-
sor. The cleaner will continue to operate properly
even though the light has been activated.
The tank status light representing the Dirty
Water Recovery Tank will blink when the tank is
full and needs to be emptied. In this state, the
cleaner will no longer dispense liquid so that the
carpet does not become over-saturated.
dealer for repair.
®
3.9 3.10
3.9 3.10
Grasp handle of
ter-top or table and
Dirty Water Recovery
remove lid by pushing
Tank and pull straight
button (A) and pivoting
up.
the lid up and away
from tank.
3.11
A
3.11
Set tank on coun- Dump dirty water
in sink or toilet. Rinse
out Dirty Recovery Tank
and be sure to remove lint
and dirt from screen (B).
3.7
3.12
B
3.12
Secure lid to tank
and place tank back
into cleaner.