After Cleaning - Hoover PLATINUM F8100900 Manual Del Propietário

4. HOW TO CLEAN
AFTE R C LE A N I N G
Unplug carpet cleaner from electrical outlet.
1. Empty any water that remains in the Clean
Water Tank.
2. If the cleaner will be stored for an extended
period of time empty the Detergent Tank.
3. Empty the Dirty Water Recovery Tank.
a. Lower cleaner handle to the floor.
b. Grasp handle of Dirty Water Recovery Tank
and pull straight up.
c. Set tank on counter-top or table.
d. Remove lid by pushing button and pivoting
the lid up and back.
e. Dump dirty water in sink or toilet.
f. Rinse tank and screen.
g. Rinse lid.
h. Secure lid to tank.
i. Place tank into cleaner.
4. Clean the Recovery Nozzle
a. Dirty Water Recovery Tank must be removed
before removing Recovery Nozzle (Fig. 4.7).
b. Push SpotFinder headlight towards back of
cleaner.
c. Lift top of Recovery Nozzle and pivot away
from cleaner.
d. Pull recovery nozzle away from latches on
the bottom of the cleaner.
20
e. Take to sink and rinse with clean water until
debris is removed (Fig. 4.8).
f. Lift bottom of cleaner 2 inches off the floor and
re-attach nozzle. Use locator tabs (A) to hinge
on nozzle.
g. Push SpotFinder headlight towards back of
cleaner.
h. Pivot Recovery Nozzle towards cleaner.
i. Release SpotFinder headlight to secure nozzle.
5. Clean the SpinScrub brushes.
TM
a. Lift base of cleaner from floor.
b. Grasp each end of SpinScrub
assembly.
c. Pull away from cleaner (Fig. 4.9).
d. Rinse with water until debris is removed.
e. To replace, align SpinScrub
f. Align SpinScrub guides with posts on
TM
cleaner.
g. Push SpinScrub assembly towards cleaner.
TM
6. For best results, all parts should be allowed to
dry before storing cleaner.
7. Do not store cleaner where temperatures could
drop below freezing (32°F, 0°C).
4.7
A
4.8
brush
TM
shaft with hole.
TM
4.9