Spot Cleaning; Rinse Only Function - Hoover PLATINUM F8100900 Manual Del Propietário

4. HOW TO CLEAN
S p o t Cle ani n g
U se f o r s p o t s , s t ai ns an d hig h tra ffi c a rea s
1. The spot sprayer has two spray patterns. Wide (A)
for treating high traffic areas and large spots and
narrow (B) for smaller areas. Turn sprayer right for
narrow and left for wide.
2. Press power button.
3. Press appropriate surface button. "Carpet" for
wall to wall carpeting. "Rug" for throw rugs, area
rugs or delicate carpet.
4. Turn cleaning mode selector dial to "SpotClean".
5. Release Handle.
6. Aim spot sprayer at problem area using the spot
finder light as your guide. Pull solution trigger to
spray solution. Be careful not to over saturate.
7. Position brush system over treated area. This
will work the solution into the fibers, releasing
the soils. Do not scrub the same area for more
than 30 seconds.
NOTE: The vacuum motor is turned off in Spot
Clean mode. This allows for maximum cleaning
effectiveness.
Always rinse areas that have been cleaned with the
Spot Clean function, this removes the soils and the
detergent from your carpet.
16
A B
Rin s e O nl y Fu nct ion
Use to re mov e soa p r esid ue or liq uid s pills
1. Press power button.
2. Press appropriate surface button. "Carpet" for wall to wall carpeting. "Rug"
for throw rugs, area rugs or delicate carpet.
3. Turn cleaning mode selector dial to "Rinse Only"
4. Release Handle.
5. A. Pull and hold solution trigger while pushing machine straight forward.
This is the first rinse cycle.
B. Continue to depress solution trigger and pull towards you. This is the
second rinse cycle.
C. Release solution trigger and push forward. This is the first dry cycle.
D. Pull towards you, this is the 2nd dry cycle.
Repeat steps C and D for drier carpets.