Braun MultiQuick 7 Manual Del Usuario página 12

Dip the puree accessory into the ingredi-
z z
ents and switch on the appliance.
Using a gentle up and down motion,
z z
move the puree accessory through the
ingredients until the desired texture is
achieved.
Release the Smartspeed switch and en-
z z
sure the puree accessory has completely
stopped turning before removing it from
the food.
After use, unplug the appliance. Remove
z z
the paddle (7c) by turning clockwise.
Press the EasyClick Plus release buttons
z z
to detach the puree accessory from the
motor part. Separate the gearbox from
the shaft by turning counterclockwise.
Caution
Never use the puree accessory in a
z z
saucepan over direct heat.
Always remove the saucepan from the
z z
heat and allow to cool slightly.
Sit the saucepan or bowl on a stable,
z z
flat surface, and support it with your free
hand.
Do not tap the puree accessory on the
z z
side of the cooking vessel during or after
use. Use a spatula to scrape excess food
away.
For best results when mashing never fill a
z z
saucepan or bowl more than half full with
food.
Do not process more than one batch
z z
without interruption.
Let the appliance cool down for 4 minutes
z z
before you continue processing.
Recipe Example: Mashed Potatoes
2.2 lbs / 1 kg cooked potatoes
7 fl. oz / 200 ml warm milk
Place the potatoes in a bowl and mash for
z z
30 seconds (3/4 way on the Smartspeed
switch).
Add the milk. Resume mashing for anoth-
z z
er 30 seconds.
12
Chopper Accessory (C)
The choppers (8/9/10) are perfectly suited
for chopping hard cheese, onions, herbs,
garlic, vegetables, bread, crackers and
nuts.
Use the «hc» chopper (8) for fine results.
Maximum operation time for the «hc»
chopper: 1 minute for large amounts of
wet ingredients, 30 seconds for dry or
hard ingredients or amounts < 4 oz / 100g.
Immediately stop processing when motor
speed decreases and/or strong vibrations
occur.
Use the «ca» chopper (9) for larger quanti-
ties and for hard foods.
Refer to the Processing Guide C for maxi-
mum quantities and recommended speeds.
Before Use
Pre-cut foods into small pieces for easier
z z
chopping.
Remove any bones, tendons and gristle
z z
from meat to help prevent damage to the
blades.
Make sure the anti-slip rubber ring
z z
(8d/9d) is attached to the bottom of the
chopper bowl.
Assembly and Operation
Carefully remove the plastic cover from
z z
the blade.
The blades (8b/9b) are very sharp! Al-
z z
ways hold it by the upper plastic part and
handle it carefully.
Place the blade on the center pin of the
z z
chopper bowl (8c/9c). Press it down and
give it a turn so that it locks into place.
Fill the chopper with food and put on the
z z
lid (8a/9a).
Align the chopper with the motor part (2)
z z
and click together.
To operate the chopper, switch on the
z z
appliance. During processing, hold the
motor part with one hand and the chop-
per bowl with the other.
Always chop harder foods (e.g. parme-
z z
san cheese) at full speed.