Troubleshooting - Amprobe LT-10 Manual De Uso

Except for the replacement of the battery, repair of the tester should
be performed only by an authorized service center or by other qualified
instrument service personnel.
The front panel and carrying case can be cleaned with a mild solution of
detergent and water. Apply sparingly with a soft cloth and allow to dry
completely before using. Do not use aromatic hydrocarbons, gasoline or
chlorinated solvents for cleaning.

TROUBLESHOOTING

Lamp tester does not work
Problem: Possible low or dead battery
Action: Check and/or replace battery
Low lamp tester response
Problem:
1. Possible low battery
2. Bad contact between the probe/antenna and the lamp tester
Action:
1. Check and/or replace battery
2. Test the area on the lamp where the probe/antenna can make good
contact against lamp glass surface or the lamp socket
Antenna does not work
Problem:
1. Possible low battery
2. Bad contact between the antenna and the lamp under test
3. Bad connection contact between the probe and antenna
Action:
1. Check and/or replace battery
2. Test the area on the lamp where the antenna can make good contact
against lamp glass surface or the lamp socket
3. Check and re-install the antenna. Make sure the antenna is securely
locked onto the probe. If the antenna is still not working, the antenna
may be damaged. Contact a service center for repair or antenna
replacement
14