Mcacc; Full Auto Mcacc; Mcacc Data Check - Pioneer VSX-534 Manual Del Usuario

3. MCACC

„ 1. Full Auto MCACC
Place the supplied speaker setup microphone in the listening position, measure
the test tones emitted by the speakers, then the unit automatically sets the
optimum volume level for each speaker, the crossover frequencies, and the
distance from the listening position. This also automatically adjusts the equalizers
for the speakers and enables correction of distortion caused by the acoustic
environment of the room.
• Calibration takes between 3 and 12 minutes to be completed. The speakers
emit the test tone at high volume during measurement, so be careful of your
surroundings. Keep the room as quiet as possible during measurement.
• If you have connected a subwoofer, check the power and volume of the
subwoofer. Set the subwoofer volume to more than halfway.
• If the power of this unit suddenly turns off, the wires in the speaker cables
may have touch the rear panel or other wires and tripped the protection circuit.
Twist the wires again properly and make sure they do not stick out of the
speaker terminals when connecting.
1. Select the connected speaker configuration.

Full Auto MCACC

Speaker Channels
Subwoofer
Height Speaker
Select how many speakers you have.
The image on the screen changes as you choose the number of channels in
"Speaker Channels", so refer to it when performing the settings.
Contents
5.1 ch
Yes
- - -
Next
ENTER
Connections
≫
2. Place the supplied speaker setup microphone in the listening position, and
connect to the SETUP MIC jack on the main unit.
SETUP MIC
When putting the speaker setup microphone on a tripod, refer to the illustration
when putting it in place.
3. Confirm a test tone is output from the subwoofer and press ENTER.
4. Test tones are emitted by the speakers, and firstly the unit detects the
speakers connected and the noise in the environment.
5. After the results of the measurements are displayed, select "Next", press
ENTER on the remote controller, and the test tones are emitted again, and the
unit automatically makes settings such as the optimum volume level and the
crossover frequency.
6. When the measurement is completed, the measurement result is displayed.
Press the cursors / on the remote controller to check the settings. Press
ENTER when "Save" is selected to save the settings.
7. Disconnect the speaker setup microphone.
„ 2. MCACC Data Check
You can check the number of speaker channels connected and the content and
values you have set for each of the speaker settings.
Speaker Setting:
You can check the number of speaker channels connected
and the large and small settings you have set for the low range reproduction
capabilities for each of the speakers.
Channel Level: You can check the output level settings for each of the speakers.
Speaker Distance: You can check the distance from each speaker to the
listening position.
73
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫