Power Management - Pioneer VSX-534 Manual Del Usuario

Setting Item Default Value Setting Details
Pairing - You can initialize the pairing information saved on
Information this unit.
Pressing ENTER when "Clear" is displayed
initializes the pairing information stored in this unit.
Device - Displays the name of the BLUETOOTH wireless
technology enabled device connected to the unit.
Status - Displays the status of the BLUETOOTH wireless
technology enabled device connected to the unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
• Wait for a while if "Bluetooth" cannot be selected. It will appear when the BLUETOOTH
function is started up.
• This function does not initialize the pairing
information on the BLUETOOTH wireless
technology enabled device. When pairing the
unit again with the device, be sure to clear
the pairing information on the BLUETOOTH
wireless technology enabled device in advance.
For information on how to clear the pairing
information, refer to the BLUETOOTH wireless
technology enabled device's instruction manual.
• The name is not displayed when "Status" is
"Ready" and "Pairing".
Contents Connections
≫
„ 3. Power Management
Change the settings for the power-save function.
Setting Item Default Value
Sleep Timer Off
Auto Standby On/Off
Auto Standby in Off
HDMI Standby
Through
USB Power Out Off
at Standby
79
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
You can allow the unit to enter standby
automatically when the specified time elapses.
Select a value from "30 minutes", "60 minutes" and
"90 minutes".
"Off": The unit does not automatically enter standby
mode.
This setting allows the unit to enter standby mode
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power Out
at Standby" is enabled, the unit enters the HYBRID
STANDBY mode which minimizes the increase in
power consumption.)
"On": The unit automatically enters standby mode
("AUTO STBY" lights up).
"Off": The unit does not automatically enter standby
mode.
• "Auto Standby" is displayed on the main unit's
display and TV screen 30 seconds before
entering standby mode.
• Default values vary depending on the regions.
Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting is enabled.
"Off": The setting is disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "Off".
When this function is set to "On", electricity can be
supplied to the device connected to the POWER
OUT port even if this unit is in standby mode .
• While using this function, power consumption
increases in standby mode, however, the
increase in power consumption is minimized by
automatically entering the HYBRID STANDBY
mode where only the essential circuits are
operating.
≫