Speaker - Pioneer VSX-534 Manual Del Usuario

2. Speaker

„ 1. Configuration
Change the settings of connection environment of the speakers.
Setting Item Default Value
Speaker 5.1 ch
Channels
Subwoofer Yes
Height Speaker Top Middle
Speaker 6 ohms or above Set the impedance (Ω) of the connected speakers.
Impedance
Setting Details
Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch",
"2.1.2 ch" or "3.1.2 ch" to suit the number of
speaker channels connected.
Set whether a subwoofer is connected or not.
"Yes": When a subwoofer is connected
"No": When a subwoofer is not connected
Set the speaker type if height speakers are
connected to the SURROUND or HEIGHT
terminals.
Select "Top Middle", "Dolby Speaker (Front)" or
"Front High" according to the type and layout of the
connected speakers.
• If the item cannot be selected even though
connection is correct, check if the setting in
"Speaker Channels" matches the number of
connected channels.
"4 ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6 ohms or above": When the connected speakers
all have 6 Ω or more impedance
• For impedance, check the indications on the
back of the speakers or their instruction manual.
Contents Connections
≫
„ 2. Crossover
Change the settings of crossover frequencies.
Setting Item Default Value
Front Small
Center Small
Height Small
70
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Large" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
≫