Technical Data; Commissioning; Switching On The Transmitter And Registering The Monitoring Station - Bosch Deepfield Connect Manual Original

12 |

Technical data

Sensor rod
Number of temperature sensors
Measuring depths
Measuring range
Measurement accuracy
in the range –10...+85 °C
Resolution
Weight
Permitted ambient temperature
for operation and storage
Dimensions
Cable length
Transmitter
Cellular network
Localization
Battery
Battery voltage
Battery self-discharge
Weight
Permitted relative air humidity for
storage
Permitted ambient temperature
for operation
Dimensions
Protection category
Deepfield Asparagus Monitoring app
Hardware requirements
Operating system

Commissioning

Installing the app on a mobile device
Install the Deepfield Asparagus Monitoring app from the
Google Play Store or the Apple App Store. To do so, follow the
instructions provided by your operating system.
Starting the app and logging in
You will have entered your e-mail address and a password
when you ordered a monitoring station from the Deepfield
Connect online shop. You can use this information to log into
the app.
Alternatively, you can register again. Deepfield Connect must
be able to contact you via the e-mail address that you provide
when registering.
 Start the app.
Asparagus Monitoring | (15.1.19)
4
0, 5, 20, 40 cm
–55...+125 °C
±0.5 °C
0.0625 °C
0,4 kg
–40...+45 °C
445  72  66 mm
2.5 m
GSM, D2 Vodafone
GPS
– Alkaline manganese
– Not rechargeable
4.5 V
4 % per year
0,9 kg
30...70 %
–20...+50 °C
200  112  80 mm
IP 67
Mobile device
(tablet, smartphone)
– Android 5.0
(and later)
– iOS 10.0 (and later)
 Select "log in".
 Enter your login data or select "register".
If you are registering again, you will be shown the criteria for
creating a secure password.
Switching on the transmitter and registering the
monitoring station
You have to switch on and register the transmitter before the
system can function. You should complete both of these steps
before installing the monitoring station in the field.
The magnet supplied is required to switch the device on. The
status LED displays the progress.
 Hold the magnet against the recess on the transmitter (see
figure 1, page 2).
The LED will light up in red and then green before going out.
You can then remove the magnet from the casing. After
switching on, it takes up to 20 minutes until the trans-
mitter is ready for use.
The transmitter cannot be switched off using the magnet. If
required, the transmitter is switched off by Deepfield
Connect over the cellular network.
You will need the app, an Internet connection and the trans-
mitter's serial number to register the device. The serial num-
ber is written on the back of the transmitter along with the
QR code.
 Start the app and select "Field management > Monitoring
stations > +".
 Follow the instructions on the display.
A video tutorial can be found at:
www.deepfield-connect.com/asparagus/support.html
Linking the monitoring station to the field
Follow these steps to link a monitoring station to a field that
you have already created in the app:
 Open the main menu and select "Field management >
Fields".
 Select the relevant field. A configuration window will
open.
All of the monitoring stations that have already been regis-
tered and assigned are listed in the configuration window.
 Select the monitoring station you wish to link to the field.
Alternately, you can register a new monitoring station
using the "+" at the end of the list.
Bosch Software Innovations GmbH, Deepfield Connect