Bresser 4CAST PC Manual Del Usario página 72

SETTING THE PRESSURE AND ALTITUDE UNITS
1. Set Local Pressure Units:
press [ SET ] until local pressure is displayed
Press and hold [ MEMORY ]
[ ] or [ ] to adjust value.
Press [ MEMORY ] to confirm your selection.
1. Set Altitude Units:
press [ SET ] until Altitude is displayed
Press and hold [ MEMORY ]
[ ] or [ ] to adjust value.
Press [ MEMORY ] to confirm your selection.
2. Set Sea-Level Pressure Units:
press [ SET ] until Sea-Level pressure is displayed
Press and hold [ MEMORY ]
[ ] or [ ] to adjust value.
Press [ MEMORY ] to confirm your selection.
VIEWING THE SEA LEVEL PRESSURE HISTORY
1. In all modes, pressing [ HISTORY ] will toggle the sea level pressure display.
2. When sea level pressure is displayed, press [ HISTORY ] repeatedly to view sea level
pressure data for each of the last 24 hours.
3. If no buttons are pressed for 5s, the display automatically show the current pressure.
VIEWING THE PRESSURE/ TEMPERATURE/ HUMIDITY BAR-CHARTS
The bar-chart on the display can be configured to display the history data for sea-level pressure,
temperature or humidity for channel 1.
In Pressure Mode, press and hold [ ALARM/CHART ] to toggle the bar-chart between:
• Sea-level pressure ("PRESSURE" should be displayed)
• Temperature (Thermometer icon and "CH1" should be displayed)
• Humidity (RH icon and "CH1" should be displayed)
72