Linking The Weather Station To A Computer; Maintenance - Bresser 4CAST PC Manual Del Usario

For the automatic backlight function, the sensitivity of the light sensor can be adjusted to high
or low with the sensitivity switch also on the back of the Main Unit
Note: Main Unit must be powered with AC/DC adaptor for automatic backlight control
function

4 LINKING THE WEATHER STATION TO A COMPUTER

Data collected by the weather station can be displayed and recorded on a computer by
connecting the main console unit with the computer via USB.
Install the software provided with the weather according to the instructions on the software
manual.
Connect the Main Unit with the computer using the USB cable provided.

5 MAINTENANCE

CHANGING BATTERIES
If the low battery indicators light up, replace the batteries for the corresponding unit
immediately.
CHANGING BATTERIES FOR THE REMOTE SENSORS
1. Replace the batteries following the setup instructions for the corresponding sensor.
2. When the batteries are properly installed, the sensor will resume sending signals to the main
console unit.
To enforce a search immediately for all remote signals, press and hold [
back of the Main Unit.
CLEANING
The Main Unit and outer casings for the remote sensors can be cleaned with a damp cloth.
Small parts can be cleaned with a cotton tip or pipe-cleaner.
Never use any abrasive cleaning agents and solvents. Do not immerse any units with electronic
parts in water or under running water.
ANEMOMETER
• Check that the wind vane and wind cups can spin freely and are free from dirt, debris or spider webs.
RAIN GAUGE
Like all rain gauges, the rain sensor is prone to blockages due to its funnel shape. Checking and
cleaning the rain sensor from time to time will maintain the accuracy of rain measurements.
• Detach the protective screen and lid. Remove any dirt, leaves or debris by cleaning the items with
soapy water and a damp cloth. Clean small holes and parts with a cotton tips or pipe-cleaner.
• Look out for spiders or insects that might have crawled into the funnel.
• Also clean the swinging mechanism with a damp cloth.
80
] located at the