Water Level For The Pump; Blocking Cutting Head - Sima PERLANATO 200 Manual De Instrucciones

3.1 WATER LEVEL FOR THE PUMP

Fill the tray to the level sufficient to cover the pump completely.
WARNING: If the water pump is not completely covered, it will
get filled with air and be burnt within a short period of time.
WARNING: Do not forget to wash the pump at the end of each day. To do this, unscrew the circular battery,
immerse the pump in a bucket of clean water, plug the machine and circulate the water until fork clean water for
cooling, disconnect the machine and screw back the cap to the pump.

3.2 BLOCKING CUTTING HEAD

When it is necessary to move the machine within the workplace once it has been unpacked, it is
recommended to empty the water from the tray before moving the machine to avoid possible splatter.
WARNING: It is also necessary to block the cutting head through its device to avoid any incidental gliding
that may damage it or damage other elements.
7