Using The Timer - Denon ADV-700 Manual De Instrucciones

[2] Using the DVD Menu
• Some DVDs include special menus called DVD menus.
For example, DVDs with complex contents may contain guide menus, and DVDs with multiple languages may contain audio
and subtitle language menus.
These menus are called "DVD menus".
Here we describe the general procedure for using DVD menus.
7 m
OOOO
®,®+ @,_©
Before operating the remote control
unit!
• Be sure to set the DVD mode using
the remote control
mode selector buttons.
During playback, press the MENU button.
• The DVD menu appears.
MENU
Remote control unit
Example:
Use the cursor or number buttons to select the desired
item.
• If you select the item using the number buttons, skip
step 3 below.
Remote control unit
C) C)
}QC)
©G(b
Remote control unit
Example:
"AUDIO" is selected
Press the ENTER button.
• The selected item is set.
• If more menus appear, repeat steps 2 and 3.
Remote control unit
_] USING THE TIMER
Example: To set the current time to "19:30"
LI---_
7 _7
Turn on the power.
Main unit
Press the TIMER/SET button and hold it in for at least 2
seconds.
• "SET TIME" is displayed.
d:'l/T"_" "_" 'r'h'H2;"
Main unit
If the time is already set, "EVERYDAY" is displayed.
Turn the FUNCTION/SELECT dial to display "SET
TIME", then continue on to step 3.
Press the TIMER/SET button.
• "Adj" is displayed and the hours' place in the time
display flashes.
Main unit
Turn FUNCTION/SELECT dial to set the hours' place to
"19".
• The "19" flashes in the hours' place.
FUNCTEON
/SELECT
Main unit
Press the TIMER/SET button.
• The "19" in the hours' place stops flashing,
remaining lit, and the minutes' place starts flashing.
Main unit
Turn the FUNCTION/SELECT dial and set the minutes'
place to "30".
• The "30" flashes in the minutes' place.
FUNCTEON
/SELECT
Main unit
Press the TIMER/SET button to start the clock running.
• The time is set and the clock starts counting the
time.
Main unit
To check the current time when something else is displayed,
press the TIMER/SET button once. The current time
appears and remains displayed until another operation is
performed.
When the TIMER/SET button is pressed again while the time
is displayed, after which the normal display reappears.
The time can be displayed by pressing the TIMER/SET
button while the power is in the standby mode. (The power
is now no longer in the energy-saving standby mode.) When
the TIMER/SET button is pressed again while the time is
displayed, after which the display turns off and the power is
set back to the energy-saving standby mode.
37