D-Link DCS-6517 Guia De Instalacion página 8

Installing the Pendant Mount (Optional)
Attach the mounting plate to the bracket cap using the
three included screws.
Locate a suitable position on the ceiling for a 34 mm
(+2 / -0 mm) hole to be cut. Use the included template
to mark and cut the mounting holes.
Locate a suitable position on the ceiling for a 34 mm
(+2 / -0 mm) hole to be cut. Use the included template
to mark and cut the wiring hole.
Drill four 6 mm holes corresponding to the holes in the
mounting template and insert the plastic anchors into
these holes.
Place the rubber seal between the pendant bracket
and the ceiling to ensure a waterproof seal between
the ceiling and the bracket.
Attach the pendant bracket to the ceiling using the
screws provided.
Attach the bracket cap to the bottom of the pendant
bracket by rotating the cap counterclockwise to tighten
it into place.
Insert the screw into the base of the pendant bracket
at the top of the bracket cap to secure the bracket cap
into place.
6
D-Link DCS-6517 Quick Installation Guide