Activating.a.station.with.the.icr - Hunter ICR Manual Del Propietario E Instrucciones De Instalación

2.. After.the.Receiver.starts.to.beep,.release.the.button.
3.. Press.either.the."ON".or."OFF".button.on.your.transmit-
ter.
4.. The.Receiver.will.beep.4.additional.times.indicating.
that.it.has.learned.the.new.Transmitter.address.and.will.
respond.only.to.it.from.this.point.on.
acTivaTing a sTaTion WiTH THe icr remoTe sysTem ......................
To remotely activate a station or program:
1.. Plug.your.Receiver.into.an.active.SmartPort
harness.(one.attached.to.a.powered.controller).and.wait.
for.2.beeps.indicating.the.Receiver.is.ready..
2.. If.your.Transmitter.is.not.on.(no.display),.press.any.
button.for.at.least.1.second.and.release..The.Transmitter.
will.display.the.active.station.
3.. Use.the. .or.
program.(A,B,.or.C).you.would.
like.to.start.
4.. Momentarily.press.the."ON".
button.to.start.the.station.or.
program..The.Transmitter.will.
display.the.word."TRANSMIT".
0
.buttons.to.display.the.station.or.
The.ICR.system.will.allow.you.to.remotely.turn.on.and.off.
any.station.on.your.Hunter.controller.with.the.press.of.a.
button..Once.on,.the.station.will.run.for.the.run.time.you.
have.designated.in.the.ICR.transmitter.
and.will.flash.for.about.4.seconds.indicating.that.it.is.
sending.the.command.to.the.Receiver..If.you.are.near.the.
.wiring.
®
Receiver,.you.will.hear.it.beep.2.times,.indicating.that.it.
has.received.the.command.
5.. Press.the."OFF".button.at.any.time.to.turn.off.the.station.
or.program..The.display.will.again.read."TRANSMIT".and.
flash,.and.the.Receiver.will.again.beep.twice..The.ICR.
is.designed.to.turn.one.station.on.at.a.time..Therefore,.
turning.a.station.on.while.another.is.already.on.will.
cause.the.first.station.to.turn.off.
6.. If.one.of.the.programs.(A,B,.C.or.P1.through.P18).
is.selected,.all.stations.in.the.selected.program.will.
run.sequentially.for.the.run.time.programmed.in.the.
controller.