Technical Data; Transport And Storage - Gude GE 235 TC Instrucciones De Operación Originales

Technical Data

Voltage/Frequency:
Max. welding current :
Regulated zone :
Electrode diameter Ø:
Idling voltage :
Protection class :
Insulation class :
Weight :
Ordering no.:

Transport and Storage

The unit should be stored at a dry place out of the reach of unauthorised persons. Make sure that the unit is
unplugged. Remember that the electrodes too have to be kept at a dry place.
Procedure
Carry out the assembly of separate parts in the order as indicated in figures. Mind the correct arrangement
of the parts.
Operation
Fig. 7
Fig. 8
The unit may be used at a room temperature from 20°C without the thermal protection being put on
-
with the number of reference electrodes n
protection on.
The earthing tongs need to be connected with the piece to be welded in a way providing for a good
-
contact. The touch points should be cleaned so that no grease or other impurities that could adversely
affect the welding output are present.
The unit has a main switch, yellow light indicator, thermal protection and a hand wheel to control the
-
welding current. The control is done with regard to welding current valuea and electrode diameter.
Ca tion: The indicators will light at overloading only.
230 V/400 V; 50 Hz
190 A
40 – 190 A
2 – 4 mm
48 V
IP 21 S
H
22,4 kg
20005
; and n
0
1. Thermal Protection indicator
2. „Stand by" Indicator
3. Welding degrees stop ring
4. Earthing connection
5. Electrode holder connection
6. Voltage selector
Having changed from 230 V to 400 V, take steps as follows:
1. Unplug the unit.
2. Put the switch at „0".
3. Remove the lock screw and fit it on the 400 V side.
4. Before putting the unit in operation again, make sure that the
knob may be turn in position 400 V and cannot be turned in
position 230 V.
from warm condition without switching the thermal
h
21
GB