Technical Data; Specified Conditions Of Use - Gude GE 185 F Manual De Instrucciones

Technical Data

GE 185 F
Art. No ...............................................................................................................................................................................................20004
Service connection .......................................................................................................................230 V / 400V ~ 50-60 Hz
Rated input voltage AC Voltage U
Protection ................................................................................................................................................................................ 16 A
Idle voltage U ...................................................................................................................................................................................48 V
0
Degree of protection ................................................................................................................................................................... IP 21S
Insulation class .........................................................................................................................................................................................F
Dimensions ......................................................................................................................................................... 550 x 320 x 380 mm
Weight ..................................................................................................................................................................................... 22 kg
..................................................................................MMA ............................................................................................WIG
Maximum rated input current I
Maximum effective input current I
Switch-on timeX* .......................................................
Welding current I .........................................................140 A ......................................................................................................170 A
2
Operating voltage U ................................................. 23,6 V ..................................................................................................... 24,4 V
2
Idle state power ....................................................................../ ................................................................................................................/
Efficiency of the Welding Power Source ............80.7% ....................................................................................................81.4 %
Material thickness ............................................1,5 - 10 mm ..........................................................................................1,5 - 10 mm
Regulated section ..................................... 40 -170 A .............................................................................................. 40 -170 A
Electrodes .................................................1,0-4,0 mm
* Actual working time and total working time ratio. Switch-on time determined at 40°C using simulation.
This device consists of the following recyclable materials:
Sheet steel, Copper, Aluminum, , ABS, PE
Read and understand the
operating instructions before
using the appliance. Abide by all
the safety measures stated in the
service manual. Act responsibly toward third parties.
In case of any doubts about connection and
operation refer please to our customer center

Specified Conditions Of Use

The device is an arc welding device with a limited
duty cycle and corresponds to class A according to
standard 60974-10. The device is suitable for occasi-
onal industrial and commercial purposes, as well as
occasional short work in the hobby and DIY sector.
We have made technical documentation for dismant-
ling, spare parts lists, circuit diagrams and a list of
recyclable materials available for you on the Internet.
You can access the technical documents using the
QR code or the corresponding link below the techni-
cal Data of these instructions.
No additional gas is required. The protective gas
is contained in the wire in powdered form, is thus
fed directly into the arc and this makes the device
resistant to wind when used outdoors.
Only wire electrodes which are suitable for the
device may be used.
........................................................................................................................... 230 V / 400V
1
29,2 A .....................................................................................................20,3 A
...........................
1max
12,09 A .....................................................................................................7,08 A
..................
1eff
20% .............................................................................................................................................................................40%
Observing the safety instructions, the assembly in-
structions and the operating instructions in the user
manual also constitutes part of the proper use.
The valid accident prevention regulations must be
adhered to strictly..
The welding device may not be used:
• in rooms that do not have sufficient ventilation
• in a damp or wet environment,
• in an explosive environment,
• to defrost pipes,
• close to people who have a pacemaker and
• close to flammable materials
Please note that our equipment has not been
designed for commercial, craft or industrial use. If the
equipment is used in commercial, craft or industrial
operation or for similar activities, we cannot assume
any liability.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
ENGLISH