Environmental Protection - Evolution EVOSAW 230 Instrucciones Originales

www.evolutionpowertools.com
BRUSH CHECKING AND/OR REPLACEMENT
• Disconnect the machine from the power
supply.
• Place the machine on a level, secure surface.
• Unscrew and remove the two (2) brush
retaining caps from the motor housing.
• Withdraw the brushes.
Note: If the carbon brush is less than ¼" long,
or if there are signs of burning or damage to
the carbon or the spring, replace the brushes.
• Fit the new brushes.
• Refit the brush retaining caps.
• Run the machine without load for several
minutes after brush replacement. This will
aid the 'bedding in' process.
Note: If, upon checking, the brushes are found
to be still serviceable, they can be returned to
their original position. It is important that they
are replaced in the same position as they were
removed from the machine.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
21
EN
ES
FR