General Specifications; Electrical Specifications - World Dryer AirMax DXM Serie Manual De Instrucciones

Description
World Dryer high performance warm air hand dryer, powered by a high speed universal motor, delivering 2300 Watts of drying power.
This hand dryer runs on 115 Volts AC or 208/220-240 Volts AC electrical supply, depending on model. Automatic and push-button
models are represented in this product group. This appliance is intended for use in hand drying, contributing to fast, hygienic and cost
effective hand sanitation. This hand dryer may be used in commercial, industrial, office and public facility environments.

General Specifications

Basic Models Nozzle Drying Cycle
Fixed
(D)XM Automatic
Fixed
(D)M 20 Seconds

Electrical Specifications

Models Type
(D) XM5 Automatic
(D) M5 Push-button
(D) XM54 Automatic
(D)M54 Push-button
(D) XM548 Automatic
(D)M548 Push-button
General Safety Information
DANGER
• Always disconnect the power source before servicing or installing the hand dryer.
DANGER
• This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground connection point is supplied on the
hand dryer's wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
WARNING
• Use only the electrical power (voltage and frequency) specified for the model hand dryer being installed.
• Connect the hand dryer to the nearest suitable distribution panel.
• To limit a voltage drop, and insure efficient operation, use wire gauge as required by local or National Electrical Code.
• Do not connect to a branch circuit with CB or fuse protection over 20 Amps. This is in compliance with The National Electrical Code
for intermittent use appliances.
• All automatic model hand dryers must have a dedicated 20 Amp circuit as required by Underwriters Laboratories, Inc. (UL).
• Route all field wiring away from any moving parts or sharp edges within the hand dryer.
CAUTION
WARNING
Unpacking
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged parts. If the
hand dryer is damaged, promptly inform the shipper or dealer where you purchased it.
CAUTION :
should be exercised when handling porcelain enameled cast iron covers. Do not drop or hit against hard
surfaces to avoid damaging the porcelain enamel.
English
Dimensions (WxDxH)
11.38" x 9.62" x 8.12"
11.38" x 9.62" x 8.12"
Electrical Input
115 VAC, 60 Hz
115 VAC, 60 Hz
208-230 VAC, 60 Hz
208-230 VAC, 60 Hz
220-240 VAC, 50 Hz
220-240 VAC, 50 Hz
Failure to disconnect the power source before installation or servicing can
result in serious injury or death from electric shock.
Failure to properly ground this unit could result in severe electrical shock
and/or death.
Risk of fire, personal injury or property damage are possible if local codes,
NEC codes or safety recommendations are not followed.
Improper mounting could result in personal injury or property damage.
Cancer and Reproductive Harm - www.p65warnings.ca.gov
2
Weight
18 / 29 lbs
18 / 29 lbs
Amperage Watts
20 2300
20 2300
10 2300
10 2300
10 2300
10 2300
Cover Material
Steel/Cast Iron
Steel/Cast Iron
(cULus Listed, E19860,
CE TUV-GS)