Dmx Linking - Chauvet Professional OVATION C-640FC Guía De Referencia Rápida

Ovation™ C-640FC QRG
AC Power
Power Linking
AC Plug
Replacing the
Fuse

DMX Linking

DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100-240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during
periods of non-use completely disconnect the product from power via
breaker or by unplugging it.
You can link up to 9 Ovation™ C-640FC products at 120 VAC or
18 at 230 VAC. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and
rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Ovation™ C-640FC will work with a DMX controller using a regular
DMX serial connection.
www.chauvetprofessional.com.
The Ovation™ C-640FC uses a regular DMX data connection for its DMX
personalities: TOUR, TR16, ARC.1, AR1.D, ARC.2, ARC.3, AR3.D, AR3.S,
PIX1, PIX3, PX16,and HSV. See the User Manual to connect and configure
for DMX operation.
Note: For optimum control of the 16-bit dimming channels in the TR16
personality, be sure that the dimming curve in SET > DIMX is set to OFF.
The Ovation™ C-640FC uses the DMX data connection for its Master/Slave
mode. See the User Manual to connect and configure for Master/Slave
operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
A DMX
3
Screw Color
Brown Yellow/Brass
Blue
Green
Primer is available
EN
Silver
from