Main Broom Height Check And Adjustment - Clarke RSW 37 Libro De Instrucciones

MAIN BROOM HEIGHT CHECK AND ADJUSTMENT

NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
1. Check the main broom distance from the fl oor as shown
below:
• Drive the machine on a level fl oor.
• Keep the machine stationary and turn on the main
broom for a few seconds.
• Stop and lift the main broom, then move the machine.
• Check that the main broom print (A, Fig. 2), along its
length, is 0.8 to 1.6 in (20 to 40 mm) wide.
• If the print (A) is not within specifi cations, adjust the
broom height as shown in step 2.
2. Drive the machine on a level ground and engage the
parking brake.
3. Turn the ignition switch (72) to "0".
4. Loosen the knobs (A, Fig. 3) on both sides of the
machine.
5. On both sides of the machine, loosen the knobs (A)
and move the broom height variation indicator (B) as
necessary, then tighten the knobs (S).
6. The indicator (B) must be in the same position on both
sides of the machine; the maximum difference allowed to
obtain the print (A, Fig. 2) shown in step 1 (0.8 – 1.6 in
(20 – 40 mm) wide) is two notches.
7. Perform step 1 again to check the proper adjustment of
the main broom height.
8. When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.
CAUTION!
If the main broom print is excessive (larger than
1.6 in (40 mm)), the machine regular operation
is affected and the moving or electrical parts
can overheat, thus reducing machine life.
Pay careful attention when performing the
above-mentioned checks, and always use the
machine according to the indicated conditions.
Operator's Manual - RSW 37
0,8 - 1,6 in
Figure 2
B
Figure 3
ENGLISH
A
S310027C
C
A
S310028C
15