Dash Disassembly - Metra 95-3528 Instrucciones De Instalación

1. Using the radio removal keys, pull
the factory radio from the dash and
disconnect the wiring. (Figure A)
2. Unsnap and remove the trim panel
at the top center of the dash above
the A/C vents and remove (4)
Phillips screws. (Figure B)
3. Remove (1) Phillips screw from inside
lower open storage area where center
console and dash meet. (Figure C)
4. Unsnap and remove center console
(open center armrest/ storage
compartment and work forward).
(Figure D)
(Figure A)

Dash Disassembly

(Figure B)
(Figure C)
(Figure D)
95-3528
5. Remove (2) Phillips screws
exposed at the bottom of the
center panel surrounding radio and
remove panel. (Figure E)
6. Unclip and remove trim panel
surrounding radio and A/C controls.
7. Remove (3) Phillips screws holding
"cage" in radio opening. (Figure F)
8. Pull down on the "cage" from the
opening inside on the top and
remove. (Figure G)
Continue to kit assembly
2
(Figure E)
(Figure F)
(Figure G)