Dash Disassembly - Metra 95-8211 Instrucciones De Instalación

Column shift models
1. Unclip and remove the trim panel below the climate
controls. Remove (2) 10mm screws now exposed.
(Figure A)
2. Carefully pull the air vents above the radio towards the
rear of car to unclip and remove them.
Note: There are (3) snaps; (2) at the bottom, towards
the sides, and (1) at the top, in the middle. (Figure B)
3. Remove (2) 10mm bolts from the top of the radio/
climate control assembly, and then unplug and remove
the entire assembly. (Figure C)
4. Remove the radio from the assembly. (Figure D)
(a) Slightly loosen (2) Phillips screws from each side
of the climate controls.
(b) Remove (4) Phillips screws from each side of
the radio, and then remove the radio from the
assembly.
Note: The climate controls and brackets
will be reused in kit assembly.
Continue to kit assembly
95-8211

Dash Disassembly

(Figure A)
(Figure B)
2
(Figure C)
(Figure D)