Kit Assembly; Important - Metra 95-8211 Instrucciones De Instalación

ISO DDIN radio provision
1. Attach the factory radio/climate brackets
removed in dash disassembly, and the ISO
DDIN trim plate, to the radio using the screws
supplied with the radio. (Figure A)
2. Gently tighten (2) Phillips screws on each side of
the climate control. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and complete
all necessary connections to the radio and
climate controls. Metra recommends using the
proper mating adapter from Metra or AXXESS.
Reconnect the negative battery terminal and
test the radio for proper operation.
4. Reassemble the dash in reverse order of
disassembly.
METRA. The World's best kits.
Installation instructions for part 95-8211

Kit Assembly

(Figure A)
™
metraonline.com

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER