Double Din Radio Provision; Stacked Iso Unit Provision - Metra 99-6510 Instrucciones De Instalación

Double DIN radio provision

1. Cut and remove center divider in
radio housing. (Figure A)
2. Snap the DDIN brackets to the
inside edge of the radio housing.
(Figure B)
3. Slide the DDIN radio unit into
the DDIN bracket/radio housing
assembly and secure the radio
unit to the kit using the screws
supplied with the radio unit.
(Figure C)
4. Snap the DDIN trim-plate onto the
housing/radio assembly. (Figure D)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
6. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-6510
(Figure A)
(Figure B)
(Figure C)
(Figure D)

Stacked ISO unit provision

1. Cut and remove center divider in
radio housing. (Figure A)
2. Snap the DDIN brackets to the
inside edge of the radio housing.
(Figure B)
3. Slide the stacked ISO DIN radio
units into the DDIN bracket/radio
housing assembly and secure the
unit to the kit using the screws
supplied with the units. (Figure C)
4. Snap the DDIN trim-plate onto the
housing/radio assembly. (Figure D)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
6. Reassemble dash in reverse order
of disassembly.
9
(Figure A)
(Figure B)
(Figure C)
(Figure D)