Iso Din Head Unit Provision With Pocket - Metra 99-5806 Instrucciones De Instalación

ISO DIN head unit provision
with pocket
1. Mount the ISO brackets to the head
unit with the screws supplied with
the unit. (Figure A)
2. Slide the head unit into the radio
opening until the side clips engage.
Snap the trim plate into the
radio housing.
Note: When reinstalling the screws
into the bottom of the 99-5806 use
the (2) supplied Phillips screws
instead of the factory screws
removed during dash disassembly.
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
4. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-5806
(Figure A)
3
Notes