Kit Assembly; Iso Din Head Unit Provisions With Pocket; Double Din Head Unit Provisions - Metra 99-3012G Instrucciones De Instalación

Ocultar thumbs Ver también para 99-3012G:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ISO DIN head unit provision with pocket
1. Install factory vents into the
radio trim panel. (Figure A)
2. Install the four included panel clips
onto the appropriate locations of
the radio trim panel.
3. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied. (Figure B)
4. Slide the head unit into radio
brackets and secure with screws
supplied with the radio. (Figure B)
5. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS. Test the unit for
operation.
6. Mount the new radio assembly into
the dash, snap-in the radio panel,
and reassemble dash in reverse
order of disassembly. (Figure C)

Kit Assembly

(Figure A)
(Figure B)
(Figure C)
99-3012G

Double DIN head unit provisions

1. Install factory vents into the
radio trim panel. (Figure A)
2. Install the four included panel clips
onto the appropriate locations of
the radio trim panel.
3. Slide the Double DIN head unit into
the radio housing brackets and
secure with screws supplied with
the unit.
(Figure B)
4. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS. Test the unit for
operation.
5. Mount the new radio assembly into
the dash, snap-in the radio panel,
and reassemble dash in reverse
order of disassembly. (Figure C)
3
(Figure A)
(Figure B)
(Figure C)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido