Kenwood KVT-827DVD Manual De Instalación página 4

Connection
When handling an optical cable for wiring, use care not
to exceed the minimum cable bend radius of 30 mm.
If you exceed the minimum bend limit, optical fibers
within the optical cable may be damaged.
An Optical cable (Accessory 3) is fixed with a chassis using
harness band (Accessory $). (KVT-827DVD/727DVD only)
For the sake of safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking brake detection
switch harness using the supplied relay connector.
To vehicle's reverse lamp harness
E
+
Battery
Antenna Cord
Accessory !
To Subwoofer system
Accessory #
(KVT-827DVD/727DVD only)
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal when using the
optional power amplifier, or to the antenna control terminal in
To "EXT.AMP.CONT. " terminal of the amplifier having the external
4
|
English
30R
To Steering remote
D
A
B
C
FM/AM antenna input
Accessory 5
If no connections are made, do not let
the cable come out from the tab.
the vehicle.
amp control function.
Optical output
(KVT-827DVD/727DVD only)
(Black)
Parking sensor wire (Green)
Reverse sensor wire (Pink)
Steering remote control input
(Light Blue/Yellow)
Dimmer control wire (Orang/White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
AV OUTPUT
AV INPUT 2
L R L
VIDEO
FM /AM ANTENNA
AV INPUT 1
L R R
VIDEO
Mute wire (Brown)
Power control/ Motor antenna control cable
(Blue/White)
External amplifier control wire (Pink/Black)
Monitor unit
Accessory 4
PRK SW
REVERSE
REMO.CONT
ILLUMI
ACC
(5A)
BATT
Receiver unit (front side)
PRE OUTPUT
REAR FRONT
L L
R-CAM V-IN CENTER
SUB
POWER
VIDEO R R
[MONO]
Accessory 1
MUTE
P. CONT ANT CONT
EXT.CONT
(10A)