Safety Regulations; Putting Into Operation; Maintenance And Cleaning - EINHELL DSW 250 Manual De Instrucciones De Operación Y Mantenimiento

Anleitung DSW 250

5. Safety regulations

Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the orbital sander to any use other than
that intended.
Keep pneumatic tools safe from children.
Always concentrate while you work. Do not work
if you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Never allow the tool to run unloaded at full idle
speed.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Wear the necessary protective clothing,
particularly goggles and safety gloves, when
working with the orbital sander.

6. Putting into operation

Screw the supplied plug-in nipple into the air
connection after you have wound 2 to 3 layers of
sealing tape around the thread.

7. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service.
Before starting to work, always check that the
sanding sheet is secure. Clean the tool thoroughly
when you are finished with your work.
Regular lubrication is vital for the long-term, reliable
operation of your orbital sander. Use only special tool
oil for this purpose.
You can choose from the following options for
lubricating the tool:
08.11.2001 8:57 Uhr Seite 5
7.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
7.2 By hand
If your air system has neither a conditioning unit nor
a line oiler, you must feed 3-5 drops of special tool oil
into the air connection each time before you use your
orbital sander. If the pneumatic tool has not been
used for several days, you must feed 5-10 drops of
oil into the air connection before you switch on.
Keep your pneumatic tool in dry rooms only.
Accessories
Special oil for pneumatic tools 500 ml
Art. No. 41.383.10
The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or unauthorized
tampering.
GB
5