Operating Mode - Stenner Pumps ECON T Serie Manual De Uso

PROGRAMMING
3. SET ADDITIONAL TIMERS: TIMER 02 THROUGH 24, AS NEEDED
Press the
TIMER
When finished setting the desired timers, press the
operating display.
NOTE: DO NOT overlap timer programs. If timers are overlapped, the first timer to
activate will run until the first OFF time of any overlapped timers is reached.
4. REVIEW PROGRAMS
Press the
TIMER
Press the
CLOCK
to AUTO. The display will show the current day, time, and the pump mode of operation.

5. OPERATING MODE

Auto
Press the
MANUAL
run at the programmed times and the display will show the last timer to run.
NOTE: When in AUTO mode, the display will show the last timer to run. If you enter into
the timer programming menu and then come back out, it will clear the indicator of the
last timer that ran and the timer indicator will be blank until a timer starts to run.
Manual
Manual mode is for priming only. If left in the manual mode, the pump will stop at
midnight (00:00) and the operating mode will have to be manually set again.
To prime the pump, press the
set to ON, it will run continuously and bypass any programmed timers. To stop the
pump from running in
button to set the pump to OFF. The pump will remain off until the operating
MANUAL
mode is changed to ON or AUTO.
continued
button and repeat the above steps for each timer.
button repeatedly to view the settings for all 24 ON and OFF events.
button to return to the operating display and set the pump operation
button to set pump to AUTO. The AUTO mode enables the timers to
MANUAL
or from running the programmed timers, press the
MANUAL
USA and Canada 800.683.2378, International 904.641.1666
CLOCK
button to set the pump to ON. When pump is
button to return to the
Econ T
13